Proscience Book a seat

Lecture 2 · Rectifiers · Note · Free

Semiconductor Electronics — Rectifiers | Notes

Chapter 14 — Semiconductor Electronics: Junction Diode as Rectifier

Class 12 Physics | Physics 2027

1. V–I characteristics of a p–n junction diode

In forward bias (p-side positive, n-side negative), current is very small until the knee/cut-in voltage; it then rises rapidly. Typical cut-in values: silicon ≈ 0.7 V; germanium ≈ 0.3 V. In reverse bias, a small nearly constant reverse saturation current flows until breakdown, when reverse current rises sharply.

VIForwardReverseBreakdownKnee

Fig. 1. Schematic V–I characteristic (not to scale).

2. Static and dynamic resistance

Static (dc) resistance: R = V/I at a specified operating point. Dynamic (ac) resistance: rd = ΔV/ΔI, the inverse slope of the I–V graph over a small interval. Example: if voltage changes by 0.10 V for a 20 mA current change, rd = 0.10/0.020 = 5 Ω.

3. Rectification
Rectification is conversion of alternating current/voltage into unidirectional (pulsating dc) output using diode(s).
4. Half-wave rectifier

A transformer secondary is connected in series with one diode D and load resistance RL. During the half-cycle that forward biases D, current flows through RL; during the opposite half-cycle, D is reverse biased and current is nearly zero. Thus only one half-cycle appears across the load. Output ripple frequency = input frequency f.

Input a.c.Half-wave output
5. Full-wave rectifier (centre-tapped)

A centre-tapped secondary transformer and two diodes D₁ and D₂ are used. The centre tap is the return connection. In the first half-cycle, end A is positive relative to centre tap: D₁ conducts, D₂ is reverse biased. In the next half-cycle, end B becomes positive: D₂ conducts, D₁ is reverse biased. In both cases current passes through RL in the same direction. Both half-cycles contribute to output; ripple frequency = 2f.

Input a.c.Full-wave output
6. Comparison
FeatureHalf-waveFull-wave
Diodes in shown circuit12, centre-tapped
Cycles usedOne half onlyBoth halves
Output frequencyf2f
RippleMoreLess
Ideal maximum efficiency≈40.6%≈81.2%

Note: A bridge full-wave rectifier uses four diodes and does not require a centre tap.

7. Filter circuits

Rectifier output is pulsating, not perfectly steady dc. A capacitor filter placed across the load charges near output peaks and discharges through RL between peaks, reducing ripple. Larger capacitance or load resistance generally reduces ripple (for the same load conditions). Filtering smooths but does not necessarily regulate output voltage.

8. Exam practice with solutions
Q1. Why does a full-wave rectifier have twice the ripple frequency?
Both positive and negative half-cycles become positive pulses, producing two output pulses per input cycle; hence fout = 2f.
Q2. An input has frequency 50 Hz. Find ripple frequency for both rectifiers.
Half-wave: 50 Hz; full-wave: 100 Hz.
Q3. Why is a filter needed?
To reduce the ac ripple component in pulsating dc and provide smoother dc across the load.

Come and see us

Message us on WhatsApp and we will answer the same day.